Temperature and Humidity Controlling System for Baby Incubator

Abdul Latif, Hendro Agus Widodo, Rachmad Andri Atmoko, Thanh Nguyen Phong, Elsayed T.Helmy

Abstract


Baby incubator is very important to keep the newborn’s body temperature especially for premature babies. The research aimed to design a baby incubator with controlled temperature and humidity. The incubator is designed to have a length of 60 cm, a width of 40 cm, and a height of 30 cm. System of baby incubator will automatically turn on or turn off the fan and or heating in accordance with the normal range of temperature and humidity in the incubator. The normal limits of temperature used is 33°C to 35°C. While the normal limits of air humidity in the incubator used is between 40% and 60%. Data acquisition system consists of temperature and humidity sensor, microcontroller ATmega8535, fan, heater, and LCD. LCD is used to display the results of measurements of temperature and humidity. Heater is used to regulate the temperature in the incubator. While fan is used to regulate the humidity in the incubator. Test results show that the heater will turn on if the temperature is below the limits of 33°C. While the fan will turn on if the humidity is above 60%

Keywords


temperature sensor; humidity sensor; baby incubator; microcontroller

Full Text:

PDF

References


D. Gao, “Design and Implementation of Intelligent Control System for Green Building,” in 2019 11th International Conference on Measuring Technology and Mechatronics Automation (ICMTMA), 2019, pp. 28–31.

S. A. Ili Flores, H. J. Konno, A. M. Massafra, and L. Schiaffino, “Simultaneous Humidity and Temperature Fuzzy Logic Control in Neonatal Incubators,” in 2018 Argentine Conference on Automatic Control (AADECA), 2018, pp. 1–6.

A. A. N. Azlin, H. Mansor, A. Z. Hashim, and T. S. Gunawan, “Development of modular smart farm system,” in 2017 IEEE 4th International Conference on Smart Instrumentation, Measurement and Application (ICSIMA), 2017, vol. 2017-Novem, no. November, pp. 1–6.

Z. Peng, “PID Control of Temperature and Humidity in Granary Based on Improved Genetic Algorithm,” in 2019 IEEE International Conference on Power, Intelligent Computing and Systems (ICPICS), 2019, pp. 428–432.

M. Li, J. Wei, and T. Shen, “Temperature and humidity decoupling control for enthalpy difference Laboratory,” in 2018 Chinese Automation Congress (CAC), 2018, pp. 1174–1178.

F. Gouadria, L. Sbita, and N. Sigrimis, “Comparison between self-tuning fuzzy PID and classic PID controllers for greenhouse system,” in 2017 International Conference on Green Energy Conversion Systems (GECS), 2017, pp. 1–6.

B. Qin, X. Wang, L. Wang, H. Zhao, X. Yin, and L. Jia, “Hydrogen Excess Ratio Control of Ejector-based Hydrogen Recirculation PEM Fuel Cell System,” in 2019 34rd Youth Academic Annual Conference of Chinese Association of Automation (YAC), 2019, pp. 648–653.

Q. Wu, W. Cai, and S. Shen, “An energy efficiency control strategy for a building-oriented dehumidification system,” in 2018 IEEE International Conference on Industrial Electronics for Sustainable Energy Systems (IESES), 2018, pp. 459–464.

D. Wicaksono, E. Firmansyah, and H. A. Nugroho, “A microclimate closed house control design for broiler strain,” in 2017 7th International Annual Engineering Seminar (InAES), 2017, pp. 1–6.

H. Zheng, X. Wang, X. Chu, and Y. Zhou, “Intelligent Systems of Climate Chamber for Water Supply Based on Feedforward PID,” in 2019 IEEE 6th International Conference on Industrial Engineering and Applications (ICIEA), 2019, pp. 819–823.

Z. Yao, J. Li, X. Zheng, and X. Zheng, “Experiments of Cryogenic Dew and Frost Point Hygrometer for Upper Air Sounding,” in IGARSS 2018 - 2018 IEEE International Geoscience and Remote Sensing Symposium, 2018, pp. 3123–3126.

M. Heidari and H. Khodadadi, “Climate control of an agricultural greenhouse by using fuzzy logic self-tuning PID approach,” in 2017 23rd International Conference on Automation and Computing (ICAC), 2017, no. September, pp. 1–6.

X. Shuang, Z. Dongyang, L. Zhen, and Z. Hui, “A Combined Control Method of Temperature and Humidity Inside the Museum Cabinet,” in 2019 11th International Conference on Measuring Technology and Mechatronics Automation (ICMTMA), 2019, pp. 322–326.

H. Wu, “Design and Implementation of a Constant Humidity Control System,” in 2018 3rd International Conference on Mechanical, Control and Computer Engineering (ICMCCE), 2018, pp. 192–195.

B. Ban and S. Kim, “Control of nonlinear, complex and black-boxed greenhouse system with reinforcement learning,” in 2017 International Conference on Information and Communication Technology Convergence (ICTC), 2017, vol. 2017-Decem, pp. 913–918.

J. Tu, B. Liu, and H. Wang, “The Multiple parameters double fuzzy decoupling PID algorithm for pig breeding system,” in 2019 6th International Conference on Systems and Informatics (ICSAI), 2019, no. Icsai, pp. 649–654.

W. Mama and T. Radpukdee, “Development of a PID Control Law for an ON/OFF Actuator with Operating Signal Saturation,” in 2018 21st International Symposium on Wireless Personal Multimedia Communications (WPMC), 2018, vol. 2018-Novem, pp. 230–235.

A. A. P. Figueroa, J. J. M. Silupu, and R. S. Garcia Zabaleta, “Adaptive PID controller with auto-tuning applied to the agricultural food industry,” in 2017 CHILEAN Conference on Electrical, Electronics Engineering, Information and Communication Technologies (CHILECON), 2017, vol. 2017-Janua, pp. 1–7.

Izhar, W. Xu, X. Wang, R. Wang, and Y.-K. Lee, “Low-Cost Micro Predictive Mean Vote (PMV) Sensor and its Application for Smart Personal Ventilation Systems,” in 2019 IEEE 32nd International Conference on Micro Electro Mechanical Systems (MEMS), 2019, vol. 2019-Janua, no. January, pp. 841–844.

A. Altayeva, B. Omarov, and Y. I. Cho, “Towards Smart City Platform Intelligence: PI Decoupling Math Model for Temperature and Humidity Control,” in 2018 IEEE International Conference on Big Data and Smart Computing (BigComp), 2018, pp. 693–696.

L. Meihui, D. Shangfeng, C. Lijun, and H. Yaofeng, “Greenhouse multi-variables control by using feedback linearization decoupling method,” in 2017 Chinese Automation Congress (CAC), 2017, vol. 2017-Janua, no. x, pp. 604–608.

L. Ilyas, E. Ahmed, and S. Nacer, “PID Controller of a MIMO system using Ant Colony Algorithm and its application to a poultry house system,” in 2019 5th International Conference on Optimization and Applications (ICOA), 2019, pp. 1–7.

F. Jiang, H. Liu, and X. Zou, “Test and Analysis of Potential Induced Degradation in Crystalline Silicon PV Modules,” in 2018 Chinese Control And Decision Conference (CCDC), 2018, pp. 4993–4996.

A. Labidi, A. Chouchaine, and A. K. Mami, “Control of relative humidity inside an agricultural greenhouse,” in 2017 18th International Conference on Sciences and Techniques of Automatic Control and Computer Engineering (STA), 2017, vol. 2018-Janua, no. 1, pp. 109–114.

S. Guo, X. Yang, J. Guo, and C. Li, “Design of Wireless Mobile Environment Monitoring System Based on Spherical Amphibious Robots,” in 2018 IEEE International Conference on Mechatronics and Automation (ICMA), 2018, pp. 960–965.

Y. R. Risodkar and D. V. Ugale, “Polyhouse Automation Using PLC,” in 2018 International Conference On Advances in Communication and Computing Technology (ICACCT), 2018, pp. 548–552.

A. Latif, H. A. Widodo, R. Rahim, and K. Kunal, “Implementation of Line Follower Robot based Microcontroller ATMega32A,” J. Robot. Control, vol. 1, no. 3, pp. 70–74, 2020.

N. H. Wijaya, F. A. Fauzi, E. T.Helmy, P. T. Nguyen, and R. A. Atmoko, “The Design of Heart Rate Detector and Body Temperature Measurement Device Using ATMega16,” J. Robot. Control, vol. 1, no. 2, pp. 40–43, 2020.

T. P. Tunggal, A. W. Apriandi, J. E. Poetro, E. T.Helmy, and F. Waseel, “Prototype of Hand Dryer with Ultraviolet Light Using ATMega8,” J. Robot. Control, vol. 1, no. 1, pp. 7–10, 2020.

S. Widadi, Z. A. Manzila, I. Ahmad, and O. Tanane, “Aroma Electric Therapy Equipment with Atmega8 -Based Heart Rate Monitoring,” J. Robot. Control, vol. 1, no. 2, pp. 49–54, 2020.




DOI: https://doi.org/10.18196/jrc.2376

Refbacks

  • There are currently no refbacks.


Copyright (c) 2020 Journal of Robotics and Control

Creative Commons License
This work is licensed under a Creative Commons Attribution-ShareAlike 4.0 International License.

 

Journal of Robotics and Control (JRC)

P-ISSN: 2715-5056 || E-ISSN: 2715-5072
Organized by Peneliti Teknologi Teknik Indonesia
Published by Universitas Muhammadiyah Yogyakarta in collaboration with Peneliti Teknologi Teknik Indonesia, Indonesia and the Department of Electrical Engineering
Website: http://journal.umy.ac.id/index.php/jrc
Email: jrcofumy@gmail.com

Kuliah Teknik Elektro Terbaik